FRP is produced using pultrusion technology and

FRP Cooling Tower Fill Honeycomb PVC Fills are used for extended contact area having high heat transfer efficiency. The crossing of air and water streams in close proximity, which creates a diffuesed turbulence conductive to evaporation and efficient heat transfer. A pre-eminent quality and long life fill consists of modular block of PVC honey combs construction to create prolonged contact time of hot air with water for maximum heat transfer. The air pressure drop through the fill is negligible. The fills available in different flute size like 6mm, 12 mm, 19 mm and 1.2 mm thichness. FRP Cooling Tower Nozzles General fill consists of Honeycomb PVC Film type splash deck is modules with high resistant to corrosion and highly efficient for heat transfer water distribution system. The hot water is raised by hot water riser and taken inside by a PVC hot water header inside. Branch distribution pipes fitted with Polypropylene Splash cups / non clogging nozzles are connected to hot water heater and uniform water distribution over entire fill is achieved. It is totaly maintenance free distribution. FRP Cooling Tower Drift Eliminator To reduce carry out losses through entrainment of moisure drops in the stream by specially designed drift elimiator made of PVC Fills. Additional PVC eliminator is provided in large capacity cooling towers. FRP Cooling Tower Motor Special low RPM totally enclosed motors of vertical, Flange type with enlarged and treaded shaft and sealed top is supplied with the cooling tower. The motor is also weather proof and in IP-55 construction. FRP Cooling Tower Supports and Hardware: All components like tower supports, motor supports, leg supports, etc., are either hot dip galvanized or epoxy coated. Hardware is Galvanized Steel. Stainless Steel or Phosphor Branze hardware can be supplied on request at extra cost. FRP Cooling Tower Fan The fan consists of axial propeller fan blades of special alloy aluminium blades of aero dynamic designed axial flow type to achieve high efficiency. Adjustable pitch blades are used for maximum utilization of applied horsepower and connected to a common Aluminum Alloy Hub. The fan is dynamically balanced. FRP fan set can also be supplied on request at extra cost. FRP Cooling Tower Energy Fans A new generation, state of the art cooling tower fans, the energy economy concept. Built with uncompromising international quality standards. Our fans are combination of performance, strength, endurance and reliability. Types of Frp Cooling Towers: 1. FRP Square Type Cooling Tower 2. FRP Bottle Shape Cooling Tower 3. FRP Seamless Cooling Tower Usage: FRP Cooling tower casing is made of selected grade materials of Fibre Glass Reinforced Plastic and resins. Additional embossing is done for extra strength. FRP casing and basins are designed to withstand severe vibration, high wind load and to resist corrosion. Water basin is completely leak proof, which avoids spillage and seepage of water. It is of deep sump to ensure maximum water level at all times and made of FRP with additional stiffening take care of extra water weight. We manufacture Bottle Shape Cooling Towers, Square Shape Cooling Towers and Seamless Cooling Towers Advantages: Power Saving: FRP fans are most efficient, consumes upto 30% less power than conventional aluminum alloy / FRP blades. Thus saving in operational cost is enormous. For more details about FRP Cooling Tower visit our website.